Mineralogical study, chemical analysis of major constituents, and heavy metal concentrations (Cd, Cr, Cu, Ni, Fe, Pb, Ag) in deposited dust from urban and industrial areas of Semnan

Document Type : Original Article

Authors

1 Associate Professor, Department of Environmental Sciences and Engineering, Faculty of Environmental Sciences, Hakim Sabzevari University, Razavi Khorasan, Sabzevar

2 Master of Environmental Sciences and Engineering, Faculty of Environmental Sciences, Hakim Sabzevari University, Sabzevar, Iran

10.22034/envj.2026.594948.1662
Abstract
Introduction: This study was conducted to investigate and identify deposited dust particles, determine the mineralogical composition and constituent compounds of these particles in the city of Semnan, and measure the concentrations of selected heavy metals, including cadmium (Cd), chromium (Cr), copper (Cu), nickel (Ni), iron (Fe), lead (Pb), and silver (Ag).
Materials and Methods: Three sampling stations were selected in Semnan City: Station 1 (Gypsum Industrial Area), Station 2 (Semnan Industrial Town), and Station 3 (City Center – Imam Khomeini Square). A Marble Dust Collector (MDCO) was designed and constructed to collect deposited dust particles. The collector consisted of a plastic container lined internally with an aluminum sheet to prevent the generation of static electricity between the dust particles and the plastic surface. A 1 × 1 cm plastic mesh was placed over the aluminum sheet to prevent trapped dust particles from being displaced out of the container. A total of 27 dust samples were collected during the autumn and winter of 2023 and the spring of 2024. The mineralogical composition, concentrations of heavy metals (Cd, Cr, Cu, Ni, Fe, Pb, and Ag), and the elemental and chemical composition of the deposited dust particles were determined. Mineralogical analysis was performed using X-ray diffraction (XRD). Heavy metal concentrations were measured using inductively coupled plasma optical emission spectrometry (ICP-OES), while the elemental composition of the dust particles was determined by X-ray fluorescence (XRF).
Results: The results indicated that the concentrations of all investigated heavy metals, except lead and silver, were highest at the Gypsum Industrial Area (Station 1), followed by the Semnan Industrial Town (Station 2). In addition, the concentrations of most measured elements were higher in autumn than in winter and spring. The XRD analysis revealed that, throughout all sampling seasons, the dust particles were primarily composed of silicates (dominant mineral: quartz), clay minerals (predominantly kaolinite, montmorillonite, and muscovite), with gypsum identified as the principal secondary mineral phase. The XRF analysis further demonstrated that SiO₂ constituted the highest proportion of the elemental composition of dust particles in Semnan.
Discussion: The high concentrations of several elements at Station 1 can be attributed to the concentration of gypsum mines in the area and its location along major road transportation and transit routes. The elevated concentrations of lead and silver at Station 2, located within an industrial zone, may be associated with the presence of chemical industries, textile and fabric manufacturing, concrete table production, machining and metal pressing industries, ceramic, tile and porcelain manufacturing, pottery production, steel reinforcing bar and iron strip manufacturing, brake lining and clutch plate production, artificial leather manufacturing, and metal electroplating industries. Compared with the average continental crust values, global soil standards, Iranian soil standards, average shale values, and previous studies conducted on soils in Razavi Khorasan Province, several elements exhibited relatively higher concentrations in the present study. The abundance of SiO₂ in the dust particles indicates the widespread occurrence of quartz in the regional soils. In sedimentary and clastic environments, quartz is the dominant mineral phase, suggesting that the dust particles in Semnan are predominantly of sedimentary origin. In addition, the CaO content was substantially higher than the global average reported for dust particles, indicating that the primary sources of dust in Semnan are arid and desert regions characterized by very low annual precipitation.

Keywords

Subjects


Articles in Press, Accepted Manuscript
Available Online from 16 November 2026